Gignosko
 
 
 
Gignosko's stats
 
  • Review count
    2
  • Helpfulness votes
    0
  • First review
    August 24, 2014
  • Last review
    August 25, 2014
  • Featured reviews
    0
  • Average rating
    3
 
Reviews comments
  • Review comment count
    0
  • Helpfulness votes
    0
  • First review comment
    None
  • Last review comment
    None
  • Featured review comments
    0
 
 
Gignosko's Reviews
 
 
Overall rating 
5 / 5
5 / 5
Triumph Explorer XC Easy Install
PostedAugust 25, 2014
Customer avatar
Gignosko
From Fort Hood
State:TX
Rider Type:Adventurer
Age:35-44
Gender:male
Bang for the Buck 
5 / 5
5 / 5
Risers went on easily and allow for an excellent upright touring position. Bolt size is same as lower bracket bolt. Recommend fitting with upper and lower bolts slightly loose, then marking the risers inside the stock bracket with a marker or lightly with a scratch awl. With risers fully installed, reaching both upper and lower bolts on stock clamps will be difficult. What worked was positioning and marking (as stated above), then rotating the risers outward by loosening the 17mm bolts that hold the bushings. Tighten all four bolts using the marks you made to line up properly, then rotate the clamps back inward and put it all back together. Wordy, yes, but it's pretty simple.
Rides: 2014 Triumph Tiger Explorer XC
Yes, I recommend this product.
0points
0of 0voted this as helpful.
 
RG Kickstand Shoe Triumph Explorer 1200 / XC Were all self conscious about our weight. No matter how many pounds youre packing, you never had to worry about sinking into the ground. On the other hand, your bike might. With the RG Kickstand Shoe you can be sure your bike will stand tall on tarmac and loose surfaces. Each kickstand shoe sandwiches the existing stand foot with an aluminum bottom, is topped with a stainless steel lid for strength and is held together with 3 hex bolts. All parts and hardware are highly corrosion-resistant. Features Enlarges the originals footprint by up to 100 Spreads out the load of the motorcycle Will not affect ground or swingarm clearance Smooth edges prevent snagging and catching
 
Overall rating 
1 / 5
1 / 5
Touches shaft drive
PostedAugust 24, 2014
Customer avatar
Gignosko
From Fort Hood
State:TX
Rider Type:Adventurer
Age:35-44
Gender:male
Bang for the Buck 
1 / 5
1 / 5
Checked fitment on a '14 Tiger Explorer XC. Would fit onto foot easily, but broduct is too wide on the rear (as deployed) or top (as stowed) side and touches the driveshaft. Sidestand cannot complete it's stowed position with this attached and creates metal to metal contact with the foot enlarger and driveshaft. Do not take this as a reason to doubt RevZ, though. Their products and service are excellent.
Rides: 2014 Triumph Tiger Explorer XC
No, I do not recommend this product.
0points
0of 0voted this as helpful.
 
Gignosko's Review Comments
 
Gignosko has not submitted comments on any reviews.