G2 Throttle Tamer Suzuki G2's challenge was to improve control of over-responsive power characteristics of most fuel injected motorcycles. Their solution is the throttle tamer. The Throttle Tamer incorporates a non-linear ratio between hand throttle rotation and carburetor or throttle body opening. The pulley, or as they call it, cam pulls the throttle cable as the rider rotates the grip/tube. By altering the conventional, circular shaped cam, a vast improvement in control is achieved. The Throttle Tamer has a cam with a reduced radius initially, which requires a slightly farther rotation to achieve the same carburetor or throttle body opening position as a stock throttle. This virtually eliminates the jerky throttle snatch especially evident in modern fuel injected street bikes. The radius increases or ramps up after throttle to keep overall rotation requires to reach full throttle at or near stock rotation. Features Machined from 6061 aluminum in the USA! Self-lubricating Delrin bushings at each end of tube eliminate aluminum-to-aluminum contact and provide an ultra-smooth feel Included cam is removable and can be replaced with alternate cams (sold separately) to fine tune control Fits inside the stock throttle housing to stock cables Works with all known aftermarket cruise controls Slide your grip unto the Throttle Tamer Note Image for reference only. Actual G2 Throttle Tamer may vary depending on your bike's make and model.